Covering Norwich and the surrounding area Monday to Friday 0900 to 1700 Request a call-out

Sonde & Tracing in North Walsham - How the Job Works, Start to Finish

A sonde and tracing job in North Walsham follows a clear sequence, and understanding each step helps you know exactly what you are paying for and what comes next.

Est. 2025 Told what it will cost before we start You see what was wrong Cleared up before we leave
Sonde & Tracing - work in progress

The process starts with a site walkthrough. Before any equipment goes into the drain, a good technician will check the inspection covers, establish the likely pipe route from the layout of the building, and ask about any known history - previous blockages, extensions built over drains, or areas of soft or sunken ground. This shapes how the survey is set up. The sonde transmitter is then attached to a push-rod or drain rod and introduced at the nearest accessible access point, usually a manhole or rodding eye. The transmitter sends a signal through the pipe wall as it travels.

Above ground, a receiver is used to track the signal, marking out the pipe route with spray paint or flags. Depth readings are taken at regular intervals - typically every metre or so - and recorded on a sketch plan or digital report. When the sonde reaches a blockage or cannot travel further, its position is marked precisely. If a camera is running alongside the sonde, the moment it reaches a defect is logged with a timestamp so it can be cross-referenced with the surface location. Once the survey is complete, the equipment is withdrawn and cleaned, the access point is replaced, and the site is left tidy. You receive a plan showing the pipe route, depths, and the exact location of any fault - giving any repair contractor or structural engineer the information they need to act.

What you get

  • Chambers lifted and the run checked, so the work starts from what is actually happening rather than from the symptom.
  • The blockage cleared with the right tool for the pipe: rods, a machine or the jetter, chosen so the pipe is not damaged getting through it.
  • The cause looked for once it runs, on camera where it is not obvious from the chamber.
  • What we found explained in plain words, with stills or footage if you want them.
  • The area washed down and the covers back properly before we leave.

Sonde & Tracing in North Walsham?

Ring and speak to the engineers who will be doing the work, or send the form with the postcode and what is happening.

Call Call-out